
8FT Tube 75W 5000K (10-Pack)
by ELEKICO
Independent guide. Not the official ELEKICO site.
A 75W, 8 ft LED tube sold in a 10-pack that swaps into fluorescent fixtures once the ballast is bypassed, rated at 9500 lumens.
Today's price and delivery date are shown on Amazon.
Check price on Amazon Read customer reviews on AmazonAs an Amazon Associate I earn from qualifying purchases.
Is it the right one for you?
Choose it if
- You have 8 ft fluorescent fixtures (T8, T10 or T12) and are willing to remove or bypass the starter and ballast.
- You want 5000K daylight white light in a garage, barn, workshop or storage area from a tube that spreads light over a 270 degree beam.
- You are refitting a long run of fixtures and need 10 tubes in one order.
- Your space is indoors and you do not need dimming, since the maker states these tubes are indoor only and non-dimmable.
Pick another if
- You want a cooler, bluer white than 5000K in a tube of the same 75W size → 8FT Tube 75W 6000K R17D (12-Pack)
- You would rather buy a complete 8FT shop light fixture than retrofit existing fixtures → 8FT Shop Light 100W (6-Pack)
- Your ceiling is high enough that a UFO high bay suits the space better than tubes → UFO High Bay 150W (6-Pack)
Key numbers
Before you buy
- Check what is in your fixture now. The maker says these tubes do not work in any fixture that still has a ballast or starter, so both must be removed or bypassed first.
- The tube is powered from both ends (double-ended). Confirm the wiring you end up with delivers power to both sockets.
- Measure the fixture. The tube is 8 ft (96 in) long and is meant for 8 ft fixtures that take T8, T10 or T12 tubes.
- The maker states these are for indoor use only, so skip them for open-air or wet locations.
- They cannot be dimmed, so do not connect them to a dimmer.
- The voltage and base type are described differently in different places, so confirm both against your fixture and the product page before ordering.
- The pack holds 10 tubes. Count your sockets first so you order the quantity you need.
Why it works
Two rows of chips are set in a V, and the maker rates the beam at 270 degrees. Light reaches surfaces beside and below the tube instead of only the floor directly underneath.
The tube replaces T8, T10 and T12 fluorescent bulbs. You remove or bypass the starter and ballast, then wire the tube directly.
The maker uses aluminum for heat dissipation and a polycarbonate cover that it describes as shatter resistant.
The operating life is rated at 50,000 hours. The maker also says the tubes run without humming or flicker.
Each tube is rated at 9500 lumens from 75 watts, in 5000K cool daylight white.
The maker lists garages, warehouses, workshops, basements, storage areas and barns as uses, and states the tube is for indoor use only.
Specifications
| Power | 75 W |
|---|---|
| Light output | 9500 lm |
| Color temperature | 5000K |
| Length | 8 ft (96 in) |
| Beam angle | 270° |
| Rated life | 50,000 hours |
| Material | Aluminum and PC |
| Dimming / use | Non-dimmable, indoor |
What's in the box
- 10 x 8ft LED tube
Questions & answers
Yes, the starter and ballast must be removed or bypassed before installation. The maker says the tube does not work in a fixture that still contains one.
Is it single-ended or double-ended power?It is double-ended power, so both ends of the tube are connected to the line.
Can it replace my T12 fluorescent tube?Yes, the maker says it replaces T8, T10 and T12 fluorescent bulbs, provided the fixture is wired as described above.
Can I use it outdoors or on a dimmer?No, the maker states it is for indoor use only and is non-dimmable.
How bright is it and what color is the light?It is rated at 9500 lumens and 5000K, a cool daylight white, from 75 watts.
How long is each tube?Each tube is 8 ft (96 in) long, and this listing is a 10-pack.
Compare ELEKICO models
8FT Tube 75W 5000K (10-Pack) | 8FT Tube 75W 6000K R17D (12-Pack) | |
| Check price on Amazon | Check price on AmazonDetails |

